Table of Contents
Advertisement
11. Press
to access the additional setup options:
a. Press
of averages taken.
b. Press
as required.
c.
Press
available options:
Hammer Point — Hammer point name is incremented each
•
time you save.
No Increase — Hammer point is not incremented.
•
Sensor Point — Measure by impacting the same location
•
and moving the sensor (sensor point name is incremented).
d. Press
interval at which points will automatically increment.
e.
Press
as required.
12. Press
to exit when you have finished selecting the required
parameters.
Section 4 — Measurement Types and their Uses
Number of Averages to change the default number
Manage Warnings > Enable or disable the warnings
Auto-Increment Upon Save to toggle between the
Point Name Increment to change the default
Sensor Setup to set up your channels and sensors
Selecting the required parameter settings
92
Advertisement
Table of Contents
