Set Ethernet Network Address; Reset Network Values To Factory Default - GE SCOUT100-Ex Reference Manual

Set Ethernet Network Address

To set the Ethernet network address:
1. Press Options on the main menu.
2. Press
Comms.
3. Press Ethernet — A message will ask whether you wish to use
a DHCP server to assign an IP address to the instrument.
4. Use EITHER of these methods according to your requirements:
Press
•
your changes.
Press
•
+
changes.
NOTE: Dynamic Host Configuration Protocol (DHCP) is a network
protocol that automatically configures TCP/IP networked devices.

Reset Network Values to Factory Default

To reset the network values to the factory default:
1. Press Options on the main menu.
2. Press
Comms.
3. Press Factory Default > Hold
your instrument.
NOTE: The factory default values are Ethernet IP: DHCP (Auto).
Section 14 — Troubleshooting
to use DHCP > Press
> Enter your new network IP values manually > Press
to reset the instrument hardware and apply your
265
+ to reset and apply
and press to reset