Connection Settings; Ethernet Communication Settings; Serial Communication Settings - HP LD4201 User Manual

Connection settings

HP Network Sign Manager supports both Ethernet and serial communications to connect to the
display. The following sections describe how to configure communication in HP Network Sign
Manager.

Ethernet communication settings

1. Click Setting on the toolbar of HP Network Sign Manager. The Setting dialog appears.
2. Select Network under Communication Select, and then click OK.
3. Click Yes to confirm and save the settings. The program exits upon confirmation. The new
settings will be applied the next time you start the program.

Serial communication settings

1. Click Setting on the toolbar of HP Network Sign Manager.
2. Select Serial under Communication Select dialog. Then, the Serial Setting fields become
activated.
3. When all fields are filled, click OK.
Item
Port
Baud Rate
Data
Parity
Stop
Flow Control
4. Click OK to confirm and save the settings. The program exits upon confirmation. The new
settings will be applied next time you start the program.
NOTE: When you run HP Network Sign Manager for the first time, the communication is set to
Ethernet (Network) by default.
ENWW
2nd Draft
Description
Communication port (COM1 - COM9), Default: COM1
Communication speed (2400 - 115200), Default: 9600
Communication data (Data5 - Data8), Default: Data8
Parity check (even, odd, none), Default: none
The number of stop bits (0 - 1), Default: 1
Data flow (Xon/Xoff, hardware, none), Default: none
Connection settings
57