Using Camera; Connecting The Device To Systems And Networks - Siemens SIMATIC ITP1000 Operating Instructions Manual

Devise functions and operating the device

4.2 Connecting the device to systems and networks

4.1.7

Using camera

Optionally, the device can be ordered with a camera.
Information on the position of the camera lens, the lighting and the LED of the camera can
be found in the section "Back (Page 14)".
The camera is operated with the pre-installed YouCam software. You can use to take
pictures and record videos. You will find information on the functions and setting options of
the camera in the documentation of the YouCam software.
Lighting and flash
Observe safety instructions
The camera LED is assigned to Risk Group 2 according to IEC/EN 62471. Before using the
flash and the light, make sure to note the safety instructions in section "General safety
instructions (Page 23)".
● The use of the lighting can be configured using the function keys. You can find additional
information in section "Buttons (Page 17)" and section "Configuring the device
(Page 45)".
● The lighting is active for 30 seconds after activation.
● The quality of the image depends on the local lighting conditions.
4.2 Connecting the device to systems and networks
The following options are available for the integration of the device in existing or planned
system environments/networks:
Ethernet
The integrated Ethernet interfaces (10/100/1000 Mbps) can be used for communication and
data exchange with programmable controllers.
WLAN
You can link the device to an Industrial Wireless LAN network using the integrated WLAN
interface.
Information on Industrial Wireless LAN can be found in SIEMENS Industrial Wireless
Communication
communications/iwlan-industrial-wireless-communication)
Further information
Additional information is available in the catalog and the online ordering system Industry
Automation and Drive Technologies - Homepage
(http://www.siemens.com/automation/service&support).
48
CAUTION
(http://www.automation.siemens.com/mcms/automation/en/industrial-
Operating Instructions, 05/2017, A5E37340160-AB
SIMATIC ITP1000