Reset Intel® Amt To Default Settings With Un-Configure; Determining The Network Address - Siemens SIMATIC ITP1000 Operating Instructions Manual

6.7.4 Reset Intel® AMT to default settings with Un-configure
If Intel® AMT was already configured, it is advisable to reset Intel® AMT to default settings.
On reset to default settings Intel® AMT is deactivated, among others.
You can skip this item if the device is still in factory state.
Note
All previous settings in the management engine MEBx are deleted.
Correct operation in the plant may be at risk.
Note down all the settings in the MEBx. Make the settings again as necessary following
Unconfigure.
1. Enable the "Unconfigure ME" entry in "Advanced > Active Management Technology
Support" in the BIOS.
2. Exit the BIOS with the <F10> key "Save and Exit". The AMT PC restarts.
3. After the restart, a user prompt appears asking whether you really want to discard all the
settings in the management engine:
4. Confirm with "Y". On a German keyboard, this means pressing the <Z> key.
The device continues to boot with the factory settings of the management engine.
6.7.5

Determining the network address

To connect the AMT PC with the AMT server, the network address that uniquely localizes
the AMT server on the AMT PC must be entered.
If DHCP is set for the automatic assignment of the network address in "Network Setup" in
the MEBx of the AMT PC, the network address is not fixed.
Procedure
If the AMT server uses the same network address as the operating system of the AMT PC
(most common situation):
1. You can obtain the address of the AMT server in the command line in Windows using
"ipconfig" and in UNIX using "ifconfig".
If the AMT server and operating system do not use the same network address, ask your
network administrator for the address you have been assigned.
SIMATIC ITP1000
Operating Instructions, 05/2017, A5E37340160-AB
Technical specifications
6.7 Active Management Technology (AMT)
99