Configure Read Point
Click
on the console main menu to view the
Read points
to configure the read point settings and view the current read points state.
Configure Read Points
Figure 4-17
Antenna Status
Displays the status of the reader read points. Click the read point status button to view and/or change the selected
antenna configuration.
•
Connected (green button):
Read point is enabled and an antenna is connected to the port.
•
Not Connected (red button):
Read point is enabled, no antenna is connected to the port.
•
User Disabled (yellow button):
Read point is disabled by the user.
Antenna Configuration
•
Choose ReadPoint
•
- User-specified read point description. Accepts up to 32 alphanumeric characters.
Description
•
User Configuration
using the port/antenna.
•
- Displays the list of air protocols the read point supports. Currently only EPC class1 GEN2 air
Air Protocol
protocol is supported.
•
- Click
Set Properties
These settings only affect the display. Use
- Select a readpoint (or all) to display the configuration.
- Enables or disables a specific read point. Disabling a read point blocks RF operation
to send the changes to the reader.
Set Properties
Commit/Revert on page 4-31
Antenna Status and Configuration
to save the changes.
Administrator Console 4 - 15
window. Use this window