Motorola fx7400 Integrator Manual page 60

4 - 22 FX Series RFID Readers Integrator Guide
LLRP Communication Configuration Options
Table 4-2
Setting
LLRP Status
Operation Mode
Client Port
Connect Status
Configuration options when LLRP in the reader is in
•
Reconnect to the server
Disable to not attempt reconnection if the connection is lost.
•
– Configures the IP address of the server.
Server IP
•
– Configures the LLRP host port to connect to. Default is 5084.
Client Port
•
Connect Status
between ConnectLLRP and DisconnectLLRP. Click ConnectLLRP to initiate an LLRP connection to the
host server.
•
To select the LLRP Client mode, check the
LLRPClient/Server Port values to connect to the client.
•
When operating in LLRP server mode, incoming requests from the client use only the LLRP Port value as the
listening port. After setting the parameters, they persist across reader reboots.
NOTE The web console parameters that affect LLRP are:
•
Region Control
•
Enable/disable antenna check
•
Monostatic configuration using advanced read point configuration page
•
Enable/disabled state of a read point class
Use the Connect LLRP/Disconnect LLRP button to immediately connect and disconnect LLRP from host.
Displays the current state of the LLRP server on the reader.
Indicates whether or not the LLRP is running.
Sets the LLPR mode in the reader.
Configures the LLRP listening port on the reader. The default is
5084.
Indicates the LLRP client connect status as connected or
disconnected. Click the button to toggle between connected or
disconnected status. This button is grayed out if there is no client
connected.
– Enable to attempt reconnection to the specified server if the connection is lost.
– Indicates whether or not the reader is connected to the LLRP host. This button toggles
Description
mode:
Client
check box. This uses LLRPClient IP and
LLRP Client Mode
Possible Values
Running
Not Running
Server
Client
ConnectLLRP
DisconnectLLRP