Panasonic MW-20EB Service Manual page 22

7.1.2. Service Mode Table 2
Item
Mode name
SD WRITE
To copy the following files into
the SD card.
* Binary file of user settings
* Error code history file
* User operation history file
SD READ To load the user setting data from
SD card to unit.
* The setting files of the other models
can not be loaded.
* Verification of each single unit is not
executed for this data loading. (If the
units are the same model, the user
setting data is exchangeable among
them)
Description
File name MINISET.DAT
Details Header Model name
File name MINIERR.DAT
Details Header Model name , 10
common error codes + 10 SD error
codes for technical inspection.
File name MINIKEY.DAT
Details Header Model name
Histories of the operations user
executed with the unit or remote
control.
(Up to 100 histories stored in
reverse chronological order)
FL display
<<Copying completed>>
* Error during copying
In the case an error occured during copying the
files to SD card, the following message is shown on
the display.
<<Loading completed>>
* Error during loading
In the case an error occured during loading the file
into the unit, the following message is shown on the
display.
22
Key operation (remote control)
Step 1 : In Service mode, press
[ ] on remote control.
Step 2 : Insert the SD card into the
unit, and then press [OK].
It shall proceed to writing data to
SD card.
Step 3 : Remove SD after copy
completes.
Step 1 : In Service mode, press
[ ] on remote control.
Step 2 : Insert the SD card into the
unit, and then press [OK].
It shall proceed to reading data from
SD card.
Step 3 : Remove SD after read
completes.