Rpci-Di Buttons And Leds - Toshiba Strata DK User Manual

RPCI-DI Buttons and LEDs

In system programming, the data telephone can be assigned data feature buttons
shown below.
Table 1 Data Feature Buttons
Button
Enables a connection between the digital telephone's RPCI-DI to another DIU in
the system when manually dialing from the telephone. When
on an idle data telephone, the system sends intercom dial tone to the telephone to
prompt dialing.
9h‡hÃ8hyy
from voice to data on external calls.
The Data Call LED lights when you receive a data call from another data telephone
or when you make a call from your data telephone, PC, or ASCII terminal. The Data
Call LED is always red when ON.
Terminates data calls. The Data Release LED never illuminates.
9h‡hÃSryrh†r
Reserves a system modem for 60 seconds. If a modem is not accessed within this
time limit, press this button again to reserve for another 60 seconds.
H‚qr€
A flashing Modem LED indicates that a modem is currently reserved for your
telephone; a continuously lit LED indicates that you have accessed a modem or
that all modems are busy. The Modem LED is always red when ON or flashing.
RPCI-DI Data Connections
See the Strata DK I&M Manual for detailed installation instructions.
If a data terminal is connected to a data telephone, the terminal must be an ASCII type
with a standard keyboard and a display screen or printer display.
If a PC is connected to a data telephone, the PC must be running at least one of the
following types of programs: word processor, desk organizer dialer, or
communications software. Also, the PC must be active (on-line) on its COM port
connected to the data telephone's RPCI-DI.
It is not possible to establish data call connections from your PC DOS prompt.
Note
Strata DK PC/Data Interface 5/00
Description
also can be used to switch data telephones and CO lines
9h‡hÃ8hyy
The Grand Tour
Integrated Data Interface Unit (RPCI-DI)
9h‡hÃ8hyy
is pressed
3