Outgoing Data Call; Dialing Through The System Modem Pool - Toshiba Strata DK User Manual

Personal computer/data interface

Hide thumbs Also See for Strata DK:

Table of Contents

Features

Outgoing Data Call

A PC involved in this type of call must be running a communications software

program. Before making this call, verify that the communication parameters of your

PC or terminal match those of the device that your are calling.

To place the RPCI-DI into the command mode while keeping the modem in the

communications mode, Toshiba recommends that the RPCI-DI escape sequence be

changed from +++ to some other sequence before beginning. For example: Using the

ATS2 command, send ATS2=36 to the RPCI-DI to change its escape sequence to

$$$. Store these commands in the PC communication software modem initialization

sequence - this sets the RPCI-DI escape sequence each time the communication

software is run.

To verify communications from your PC or terminal

Type AT, and press

Enter on your PC or

terminal.

Wait for the following to display on your PC or

terminal screen.

This display verifies that communications exist

between your PC or terminal and your data telephone.

Note

AT commands must be typed as capital letters

(use caps lock), and they appear on your PC or

terminal screen as you type them.

Strata DK PC/Data Interface 5/00

Table of Contents