Ac Power Cord; Trunk/Extension Cabling; General; Figure 2-11 Ac Power Cord - NEC SL1100 Hardware Manual

SL1100
Frequency
Phase and Wire
Ground Requirement
Feeding Voltage
AC Input I
KWh
BTU (KWh x 3413)

1.4.3 AC Power Cord

The AC power switch and AC power inlet are located at the left side of the KSU. The AC power cord is
connected to the AC inlet and the commercial AC power socket.
Do not plug-in AC power cord if the KSU Cover is removed.
Before connecting the AC power cord, make sure:
• The power switch at the left side of the KSU is turned OFF.
• The power switch at the commercial AC power socket is turned OFF.
• The AC plug fits the commercial AC power socket. The plug adapter is
necessary if it does not fit.
Type 3-pin Plug
To Commercial
AC Power Socket
• KSU must have its own commercial AC power socket.
• DO NOT POWER ON until KSU installation has been completed.

1.5 Trunk/Extension Cabling

1.5.1 General

The system provides RJ61 modular jacks for analogue/digital extension connections.
2-8
110VAC 120VAC
47 Hz - 63 Hz (Rated Frequency: 50/60 Hz)
Single Phase, 2 Line + PE Type
Main KSU = Main KSU =
1.16 A 1.08 A
Main KSU = Main KSU =
0.128 KWh 0.130 KWh
Main KSU = Main KSU =
437 BTU 444 BTU
Connect
AC Power Cord

Figure 2-11 AC Power Cord

220VAC 230VAC
No.14 AWG Copper Wire
SLT: 20 mA/ -27 V
Main KSU = Main KSU =
0.70 A 0.67 A
Main KSU = Main KSU =
0.154 KWh 0.154 KWh
Main KSU = Main KSU =
526 BTU 526 BTU
ISSUE 4.1 (R5.1)
240VAC
Main KSU =
0.65 A
Main KSU =
0.156 KWh
Main KSU =
532 BTU
KSU
Installation