Mounting The Device To A Panel; Connecting Power - Siemens RUGGEDCOM RX1400 Installation Manual

Chapter 2
Installing the Device
Figure 3: DIN Rail Mounting
1. Panel/DIN Rail Adapter
2. Install one of the supplied screws on either side of the device to secure the adapters to the DIN rails.
Section 2.2.3

Mounting the Device to a Panel

For panel installations, the RX1400 can be equipped with panel adapters pre-installed on each side of the
chassis. The adapters allow the device to be attached to a panel using screws.
To mount the device to a panel, do the following:
1. Place the device against the panel and align the adapters with the mounting holes.
Figure 4: Panel Mounting
1. Screw 2. Panel Adapter
2. Install the supplied screws to secure the adapters to the panel.
Section 2.3

Connecting Power

The RX1400 supports a single integrated low DC power supply.
8
1
2. DIN Rail 3. Screw
1
2
RUGGEDCOM RX1400
Installation Guide
1
2
1
2
Mounting the Device to a Panel