Siemens RUGGEDCOM RX1400 Installation Manual page 9

RUGGEDCOM RX1400
Installation Guide
▪ ALARM LED – Illuminates when an alarm condition exists.
▪ CELL LED – Indicates when the cellular modem is connected to the network.
○ Solid = Activity
○ Off = No activity
▪ Port Status LEDs – Indicate the status of each port:
○ Solid = Link
○ Blinking = Activity
○ Off = No link/activity
• Access Plate – The removable access plate provides access to the Micro SD card and SIM card slots.
▪ Use a Micro SD card to store the firmware and configuration for the device
▪ Use a single or dual (recommended) SIM cards to connect to an LTE network
• RS232 Serial Console Port – The serial console port is for interfacing directly with the device and accessing
initial management functions. For information about connecting to the device via the serial console port, refer to
Section 2.7, "Connecting to the
• LTE MAIN, LTE MIMO and GPS Ports – SMA ports for connecting to an LTE network or Global Navigation
Satellite System (GNSS). For more information, refer to:
▪ Section 2.4, "Installing the Antennas"
▪ Section 4.6, "Cellular Modem Specifications"
• Failsafe Alarm Relay – Latches to default state when a power disruption or other alarm condition occurs. For
more information, refer to:
▪ Section 2.6, "Connecting the Failsafe Alarm Relay"
▪ Section 4.2, "Failsafe Alarm Relay Specifications"
• Power Supply Terminal Block – A pluggable terminal block. For more information, refer to:
▪ Section 2.3, "Connecting Power"
▪ Section 4.1, "Power Supply Specifications"
Description
Device".
Chapter 1
Introduction
3