Motorola APX 3000 Basic Service Manual page 99

Disassembly/Reassembly Procedures: Serviceable Components of the Main Sub-Assemblies
6. Apply slight pressure for approximately 30 seconds to activate the adhesive.
8.5.2.3 Servicing Battery Contact Seal:
1. Complete steps from
2. Pinch the Battery Contact Seal inwards and remove it from the chassis opening.
3. Slot the new Battery Contact Seal until it is properly seated onto the Chassis surface.
8.5.2.4 Servicing Main O Ring:
1. Complete steps from
2. Remove the Main O Ring with the aid of a Black Stick.
3. Replace the new Main O Ring into the groove provided in the Chassis.
4. Ensure that the seal is set properly and not stretched
8.5.2.5 Servicing Shroud Label, NFC flex and Lightpipe:
1. Complete steps from
2. Remove the Shroud Label with the aid of a Black Stick.
3. Remove the Chassis Screw at the center of shroud.
4. Remove the Shroud with the aid of Black Stick.
5. Remove the Lightpipe from the Chassis.
6. Replace the new Lightpipe into the Chassis. Ensure that the seal is set properly and not
stretched.
7. Replace the new Shroud and torque the Chassis Screw with 3.0 in-lbf with a Torx IP6 Bit.
8. Peel the new Shroud Label of its backer and place it in the original location.
9. Apply slight pressure to set the adhesive.
Seal, Vacuum Port should always be replaced when back kit
assembly is removed.
Section 8.4.4.1.
Section 8.4.4.1.
Section 8.4.
through Section 8.4.4.3.
through Section 8.4.4.3.
8-13