Toshiba MML-AP0124H2UL Service Manual page 39

Confirmation of indoor unit No. position
1. To know the indoor unit addresses though position of the indoor unit is recognized
• In case of individual operation (Wired remote control : indoor unit = 1 : 1)
(Follow to the procedure during operation)
<Procedure>
1
Push button (button at left side) if the
unit stops.
2
Push button (button at left side).
UNIT LOUVER
Unit No. 1-1 is displayed on LCD.
(It disappears after several seconds.)
The displayed unit No. indicate line address and
indoor unit address.
(When other indoor units are connected to the
identical remote control (Group control unit), other
unit numbers are also displayed every pushing
button(button at left side).
UNIT LOUVER
2. To know the position of indoor unit by address
• To confirm the unit No. in the group control
(Follow to the procedure during operation) (in this procedure, the indoor units in group control stop.)
<Procedure>
The indoor unit numbers in the group control are
successively displayed, and fan, louver, and drain
pump of the corresponding indoor unit are turned on.
(Follow to the procedure during operation)
1
Push and
for 4 seconds or more.
ALL
• Unit No. is displayed.
• Fans of all the indoor units in the group control
operate.
2
Every pushing
UNIT LOUVER
side), the unit numbers in the group control
are successively displayed.
• The unit No. displayed at the first time indicates
the master unit address.
• Fan of the selected indoor unit only operate.
3
Push button to finish the procedure.
All the indoor units in the group control
stop.
buttons simultaneously
button(button at left
TEMP.
FILTER
RESET TEST
<Operation procedure>
1 2
END
TEMP.
1
FILTER
RESET TEST
3
<Operation procedure>
1 2 3
– 39 –
F
ON / OFF
Operation
TIMER SET FAN MODE
TIME SAVE VENT
SET CL SWING/FIX UNIT LOUVER
ON / OFF
TIMER SET FAN MODE
TIME SAVE VENT
SET CL SWING/FIX UNIT LOUVER
END
1
2
2