Mounting Base Unit On The Din Rail; Mounting The Base Unit On The Din Rail - Mitsubishi Electric MELSEC iQ-R Series Configuration Manual

5.4

Mounting Base Unit on the DIN Rail

Mounting the base unit on the DIN rail

This section describes the installation method for a base unit to a DIN rail.
A DIN rail adapter (sold separately) is required to install the base unit to the DIN rail.
For the MELSEC-Q series extension base unit, refer to the following.
 QCPU User's Manual (Hardware Design, Maintenance and Inspection)
Applicable DIN rail adapter model
■ Main base unit, extension base unit
• For R3B, R3B-HT, R6B, R6B-HT, R3RB, R3RB-HT, R6RB, R6RB-HT: R6DIN1
Model Pieces
Hook A
R6DIN1 2
■ RQ extension base unit
Use the MELSEC-Q series DIN rail adapter for the RQ extension base unit.
• For RQ68B, RQ612B: Q6DIN1
• For RQ65B: Q6DIN2
Model Pieces
Adapter (larger)
Q6DIN1 2
Q6DIN2 2
Applicable DIN rail model (IEC 60715)
• TH35-7.5Fe
• TH35-7.5Al
• TH35-15Fe
Hook B-C (with two Stopper
mounting screws)
2 2
Adapter (smaller) Stopper
4 2
3 2
Square washer Mounting screw
(M510)
3 3
Square washer Mounting screw
(M510)
3 3
2 2
5 INSTALLATION AND WIRING
5.4 Mounting Base Unit on the DIN Rail
5
105