Table of Contents
Advertisement
This causes the debugger to allow exceptions to be handled as they would be
by the processor. In Report mode, the debugger reports the exception type,
and where it occurred to the Journal window, and then handles the exception
as the processor would. In the Stop mode, the debugger reports the exception
to the Journal window and halts program execution. This is the default mode
of operation.
Step Speed
The Step_Speed option specifies the stepping speed. The stepping speed can
be in the range of 0 to 100 units. Higher numbers represent slower speeds.
This option affects the Program Step command. The default value is 0.
See Also
File Startup
Debugger Option List
Example
To align assembly-level breakpoints at the beginning of an instruction:
Debugger Option General Align_Bp On
Chapter 9: Debugger Commands
Debugger Option General
297
Advertisement
Table of Contents
