Table of Contents
Advertisement
Chapter 12: Debugger Error Messages
74
Invalid level number. Must be 1 to 7.
The Program Interrupt Add command, as well as the 68000 family of
microprocessors, permit 7 levels of interrupts.
75
Attempt to delete nonexistent breakpoint(s).
You tried to clear a breakpoint that was not previously set. Check that the
breakpoint was set, or not already cleared.
76
Symbol not available from this scope unreferenced.
You must reference the symbol with a qualified function or module name.
77
Symbol with this name already exists.
You tried to define a symbol that was previously defined. Another name
should be used.
78
Cannot create this symbol.
An error occurred when trying to create the symbol. Check that it is valid as a
symbol name.
79
Symbol is not a module.
An attempt was made to enter a symbol when a module was expected.
80
Invalid stack level.
This error indicates that a stack level was specified that is greater than the
current stack nesting.
81
Not a source function.
An attempt was made to enter an illegal function with the Program Context
Set command. The Program Context Set command requires either a module
name or a source procedure name.
82
Cannot delete this symbol.
Registers and predefined symbols cannot be deleted.
492
Advertisement
Table of Contents
