Table of Contents
Advertisement
Chapter 9: Debugger Commands
Debugger Quit
Debugger Quit
The Debugger Quit command ends a debugging session without saving the
session. If you enter the command Debugger Quit Yes , the debugging
session is immediately ended. If you enter the command Debugger Quit
without an option, the debugger asks the question "Are you sure?". If you reply
yes, the debugging session is ended. Otherwise the debugging session continues.
The Debugger Quit command does not save the debugging session. Use the
File Startup command to save the current set of debugger startup options and
window parameters in a startup file.
Note
If you want to save the debugging session, use the Debugger Execution
Save_State command to save the current memory contents and register values.
This command is not available with the debugger/emulator products.
See Also
Debugger Host_Shell
Examples
To end the debugger/simulator session:
Debugger Quit
The debugger will prompt you with the question "Are you sure?" before ending
the session.
To terminate the debugging session immediately:
Debugger Quit Yes
306
Advertisement
Table of Contents
