Link-Aggregation Port-Priority; Link-Aggregation Selected-Port Maximum - HP 3600 v2 Series Command Reference Manual

Description
Use the link-aggregation mode dynamic command to configure an aggregation group to operate in
dynamic aggregation mode.
Use undo link-aggregation mode to restore the default setting.
By default, an aggregation group operates in static aggregation mode.
To change the aggregation mode of an aggregation group that contains member ports, remove all the
member ports from the aggregation group first.
Examples
# Configure the aggregation group corresponding to Bridge-Aggregation 1 to operate in dynamic
aggregation mode.
<Sysname> system-view
[Sysname] interface bridge-aggregation 1
[Sysname-Bridge-Aggregation1] link-aggregation mode dynamic

link-aggregation port-priority

Syntax
link-aggregation port-priority port-priority
undo link-aggregation port-priority
View
Ethernet interface view
Default level
2: System level
Parameters
port-priority: Specifies a port aggregation priority, in the range of 0 to 65535. The smaller the value, the
higher the port aggregation priority.
Description
Use link-aggregation port-priority to set the aggregation priority of a port.
Use undo link-aggregation port-priority to restore the default setting.
The default aggregation priority of a port is 32768.
Examples
# Set the aggregation priority of port Ethernet 1/0/1 to 64.
<Sysname> system-view
[Sysname] interface ethernet 1/0/1
[Sysname-Ethernet1/0/1] link-aggregation port-priority 64

link-aggregation selected-port maximum

Syntax
link-aggregation selected-port maximum number
undo link-aggregation selected-port maximum
95