Layer 3 Ethernet Interface Configuration Commands; Mtu - HP 3600 v2 Series Command Reference Manual

Examples
# Test the cable connection of Ethernet 1/0/1.
<Sysname> system-view
[Sysname] interface ethernet 1/0/1
[Sysname-Ethernet1/0/1] virtual-cable-test
Cable status: normal, 1 metres
Pair Impedance mismatch: -
Pair skew: - ns
Pair swap: -
Pair polarity: -
Insertion loss: - db
Return loss: - db
Near-end crosstalk: - db
NOTE:
The Pair Impedance mismatch field has the following values:
Yes—Match
•
No—Mismatch
•

Layer 3 Ethernet interface configuration commands

mtu

Syntax
mtu size
undo mtu
View
Layer 3 Ethernet interface view
Default level
2: System level
Parameters
size: Sets the maximum transmission unit (MTU) in bytes, which ranges from 46 to 1560.
Description
Use mtu to set the MTU for a Layer 3 Ethernet interface.
Use undo mtu to restore the default.
By default, the MTU of a Layer 3 Ethernet interface is 1500 bytes.
Examples
# Set the MTU to 1430 bytes for the Layer 3 Ethernet interface Ethernet 1/0/1.
<Sysname> system-view
[Sysname] interface ethernet 1/0/1
[Sysname-Ethernet 1/0/1] mtu 1430
48