Stp Priority - HP 3600 v2 Series Command Reference Manual

By default, this function is enabled.
Examples
# In MSTP mode, enable outputting port state transition information for MSTI 2.
<Sysname> system-view
[Sysname] stp port-log instance 2
%Aug 16 00:49:41:856 2006 Sysname MSTP/3/MSTP_DISCARDING: Instance 2's Ethernet1/0/1 has
been set to discarding state!
%Aug 16 00:49:41:856 2006 Sysname MSTP/3/MSTP_DISCARDING: Instance 2's Ethernet1/0/2 has
been set to forwarding state!
The output shows that Ethernet 1/0/1 in MSTI 2 transited to the discarding state and Ethernet 1/0/2 in
MSTI 2 transited to the forwarding state.
# In PVST mode, enable outputting port state transition information for VLAN 1 to VLAN 4094.
<Sysname> system-view
[Sysname] stp mode pvst
[Sysname] stp port-log vlan 1 to 4094
%Aug 16 00:49:41:856 2006 Sysname MSTP/3/PVST_DISCARDING: VLAN 2's Ethernet1/0/1 has been
set to discarding state!
%Aug 16 00:49:41:856 2006 Sysname MSTP/3/PVST_FORWARDING: VLAN 2's Ethernet1/0/2 has been
set to forwarding state!
The output shows that Ethernet 1/0/1 in VLAN 2 transited to the discarding state and Ethernet 1/0/2
in VLAN 2 transited to the forwarding state.

stp priority

Syntax
stp [ instance instance-id | vlan vlan-list ] priority priority
undo stp [ instance instance-id | vlan vlan-list ] priority
View
System view
Default level
2: System level
Parameters
instance instance-id: Sets the priority of the device in an MSTI. The value of instance-id ranges from 0 to
32, where 0 represents the CIST.
vlan vlan-list: Specifies a VLAN list in the format of vlan-list = { vlan-id [ to vlan-id ] }&<1- 1 0>, where the
vlan-id argument represents the VLAN ID, ranges from 1 to 4094, and &<1- 1 0> indicates that you can
specify up to 10 VLAN IDs or VLAN ID ranges.
priority: Specifies a device priority, in the range of 0 to 61440 in increments of 4096 (as in 0, 4096,
8192). You can set up to 16 priority values on the device. The smaller the value, the higher the device
priority.
Description
Use stp priority to set the priority of the device.
Use undo stp priority to restore the default priority.
140