Names Of Parts - NEC DS1-MP10RX series Operation Manual

① HDMI output port
② Power button
③ ⑨ Exhaust vents
④ DC IN jack
⑤ USB port
⑥ Security hanger
⑦ Power indicator
⑧ Strap holes
⑩ microSD card slot

3. Names of parts

Use the included HDMI extension cable to connect to the HDMI input port on a display
or projector.
This turns the power on and off.
To turn the power off, press and hold the button (for about 5 seconds).
These discharge the heat inside the frame.
NOTE: Do not block the exhaust vents.
Connect the included AC adapter here.
NOTE: When connecting the AC adapter to the MultiPresenter Stick, check the direc-
tion of the jack.
A USB mouse (commercially available) can be connected here to make the settings of
the MultiPresenter Stick.
A wired network adapter (commercially available) can also be connected here.
Install a commercially available theft prevention wire here.
This indicates the power status.
When power is on: Lit blue
When power is off: Off
To fix the MultiPresenter Stick in place, put a commercially available strap, etc., through
these holes.
NOTE: Do not use conductive wires. Doing so may decrease the wireless LAN sensitiv-
ity.
* This slot cannot be used. Do not remove the cover.
7