Machine the workpiece
3.1 Starting program execution
Note
Starting the program in any operating area
If the control is in "AUTO" mode, you can also start the selected program when you are in
any operating area.
Stopping machining
Canceling machining
58
Press the "CYCLE STOP" key.
Machining stops immediately. Individual program blocks are not
executed to the end. On the next start, machining is resumed
from the point where it left off
Press the "RESET" key.
Execution of the program is interrupted. On the next start, machining
will start from the beginning.
Machine manufacturer
Please also refer to the machine manufacturer's instructions.
Operating Manual, 11/2006, 6FC5398-6AP10-1BA0
HMI sl Universal