Site Controller - Gps Module; Site Controller - Lithium Battery; Resetting The Rtc Battery Status - Motorola DIMETRA MTS 4 Installation, Configuration, And Service Manual

Applicant: Motorola Solutions
Track ID not mapped:
JTH0500102
3 On the list, locate the unit that you have removed and that is indicated as Units are not present.
4 Delete old CAN Bus unit from the CAN Bus unit mapping list. Type can remove_mapping <Device>,
where <Device> is the old unit name. See example below:
SC> can remove_mapping dpm 2
5 Add new CAN Bus unit to the CAN Bus unit mapping list.
Use can add_mapping <Device> <TrackID>, where< TrackID> is a TrackID of the new unit and
<Device> is the new unit name. Units have the following names: psu X, dpm X, atcc X, where X denotes a digit
between 0 and 3. See example below:
SC> can add_mapping dpm 2 JTH0500102
6 View the updated mapping list using the can check_mapping command and check that there are no units
labeled as Track ID not mapped or Units are not present.
Site Controller – GPS Module
The GPS module generates a highly accurate timing reference signal within the Base Station. To do this a proper GPS
signal must be provided to the QMA input connector on the Site Controller Front Panel. The Site Controller provides
a +5 V dc supply voltage on the QMA connector. It is intended to be used to provide a voltage supply for active
antennas.
Note:
See
See respective restoration manual (DIPS/DIPC systems) or Service Manual (DIPM system) for procedures
on how to verify the internal and external GPS module.
Site Controller – Lithium Battery
This section contains procedures on how to check if the lithium battery needs changing and how to correctly replace
it.

Resetting the RTC Battery Status

The following procedure describes how to reset the status of the RTC battery. Perform this procedure after each RTC
battery replacement.
Procedure:
In TETRA Application, enter hw rtc reset batteryStatus
The following message appears:
reset RealTimeClock battery status
- Status: OK
Note: The new unit Track ID is present on the replaced unit label and indicated as Track ID not
mapped in the list shown in
Hardware Installation on page 75
step 2.
for description of external GPS.
6802800U74-AD | September 2014 |
Equipment Type: ABZ89FC5827 / 109AB-5827
Site Controller | 275
Send Feedback
Exhibit D2