Table 87: Base Radio - Connectors - Motorola DIMETRA MTS 4 Installation, Configuration, And Service Manual

Applicant: Motorola Solutions
292 | Base Radio
# LED/Port name
LED 2 Aux
LED 3 Status
LED 4 BR Alarm
LED5 SC 1
LED6 SC 1
LED7 SC 2
LED8 SC 2
Table 87: Base Radio – Connectors
Name of
Connector
SC1
SC2
Service
RX1
Send Feedback | September 2014 | 6802800U74-AD
Type
Red/Green
Red/Green
Red/Green
Green
Yellow
Green
Yellow
Type
RJ45
RJ45
RJ45
QMA
Controlled by
• AMBER: BR is keyed without serv-
ice
• GREEN: BR is keyed
SW
• OFF: No alarms
• AMBER: not used
• RED: not used
SW Red LED will BR status:
turn on before SW
• OFF: Status unknown, power off
change any indi-
• GREEN: BRC main application is
cation
running
• AMBER: Waiting for SWDL this is
where the BR will wait if no Site
Controller is present
• RED: SW not started, power on
SW
• OFF: No alarms
• AMBER: BR minor alarm: PA, Ex-
citer, RX, BRC Reduced perform-
ance
• RED: BR failed: PA, Exciter, RX,
BRC
HW, Enet IC
• OFF: Ethernet link not present
• GREEN: Ethernet link present
HW, Enet IC
• OFF: Ethernet activity not present
• YELLOW: Ethernet activity present
HW, Enet IC
• OFF: Ethernet link not present
• GREEN: Ethernet link present
HW, Enet IC
• OFF: Ethernet activity not present
• YELLOW: Ethernet activity present
To/From
Site Controller Ethernet/CP2 interface
Site Controller Ethernet/CP2 interface
BRC Provides service access. See
88: Base Radio – Service Cable
Pinouts on page 293
ble pinout information.
Preselector/ Duplexer RF RX signal and +7 V dcl
Equipment Type: ABZ89FC5827 / 109AB-5827
Indication
Comment
Table
for service ca-
Table continued...
Exhibit D2