Hybrid Combiner Expansion; Installing An Additional Hybrid Combiner; Configuration; Expansion From Mts 2 To Mts 4 Cabinet - Motorola DIMETRA MTS 4 Installation, Configuration, And Service Manual

Applicant: Motorola Solutions
398 | Expansion Options

Hybrid Combiner Expansion

It is possible to expand the MTS 4 with additional Hybrid Combiner.
Note: The additional Hybrid Combiner is delivered with the expansion kit that includes required equipment
and cables.

Installing an additional Hybrid Combiner

Follow the instructions below to install the additional Hybrid Combiner.
Procedure:
1 Switch OFF the Power Supply Unit.
2 Assemble the Bracket with the three M6x10 screws.
3 Fasten the two M4x10 screws that are to hold the Hybrid Combiner but do not tighten them fully.
4 Place the Hybrid Combiner on the bracket of the cabinet with the heat sink facing the side of the cabinet.
5 Slide the Hybrid Combiner at an angle ensuring that the lip at the back of the Hybrid Combiner is secured behind
the bracket.
6 Tighten the two M4x10 screws to the bracket.
7 Attach the TX and antenna cables.
8 Switch ON the Power Supply Unit.

Configuration

No further configuration is needed when having installed the Hybrid Combiner.

Expansion from MTS 2 to MTS 4 Cabinet

It is possible to expand from an existing MTS 2 to MTS 4.
Note: When expanding from MTS 2 to MTS 4, an additional Base Radio is delivered with the expansion
kit that includes required equipment and cables.

Expanding from MTS 2 to MTS 4

Follow the process below to extract the Module Cage from MTS 2 and assemble it into the expanding MTS 4
Cabinet.
Process:
1 Extract the Module Cage from MTS 2, see
2 Assemble the Module Cage in the MTS 4 cabinet, see
400

Extracting the Module Cage from MTS 2

Procedure:
1 Remove all RF cables (RX, TX, and GPS if mounted).
2 Disconnect all cables between the module cage and the Junction Panel.
3 Remove any CAN Bus cables going to and from the Filter(s).
Send Feedback | September 2014 | 6802800U74-AD
Equipment Type: ABZ89FC5827 / 109AB-5827
Extracting the Module Cage from MTS 2 on page
Assembling the Module Cage in the MTS 4 Cabinet on page
398.
Exhibit D2