Mts 4 Duplexer - Motorola DIMETRA MTS 4 Installation, Configuration, And Service Manual

Applicant: Motorola Solutions
Reinstalling the MTS 4 Preselector
Procedure:
1 Fasten the Preselector onto the bracket.
2 Slide the Preselector into the cabinet.
3 Tighten the two fastening screws at the front.
4 Screw on the antenna cable and connect the RX cables to the back of the Preselector.
5 Slide on the top rear and front panels and fasten these with screws.
6 Put the front panel back on and screw this into place.
7 Put the door of the cabinet back on.

MTS 4 Duplexer

The Duplexer is a Preselector with an integrated receiver multicoupler (RMC) and a Post Filter with a digital power
monitor (DPM) combined into one unit. These form the two bandpass filters that make up the Duplexer; one is a
receive filter and the other a transmit filter. See the block schematic of the MTS 4 Duplexer in
Diagram of MTS 4 Duplexer on page 248
For 400 MHz, the duplex spacing between a transmitter frequency and the corresponding receive frequency is 10
MHz, with the transmitter frequency highest. This leaves a 5 MHz spacing between the lowest possible transmit
frequency and the highest possible receive frequency.
For 260 MHz, the duplex spacing between a transmit frequency and the corresponding receive frequency is 9 MHz,
and leaves a 3 MHz spacing between the lowest possible transmit frequency and the highest possible receive
frequency.
For 800 MHz, the duplex spacing between a transmit frequency and the corresponding receive frequency is 45 MHz,
and leaves a 19 MHz spacing between the lowest possible transmit frequency and the highest possible receive
frequency.
The MTS 4 Duplexer has 4 RX outputs and one expansion output. It can handle a maximum power 180 Watts.
Equipment Type: ABZ89FC5827 / 109AB-5827
Radio Frequency Distribution System | 247
6802800U74-AD | September 2014 |
Figure 154: Schematic
Send Feedback
Exhibit D2