Troubleshooting Msdp; Msdp Peers Stay In Disabled State; No Sa Entries Exist In The Router's Sa Message Cache; No Exchange Of Locally Registered (S, G) Entries Between Rps - HP MSR1002-4 Configuration Manual

10.110.3.100
10.110.3.100

Troubleshooting MSDP

This section describes common MSDP problems and how to troubleshoot them.

MSDP peers stay in disabled state

Symptom
The configured MSDP peers stay in disabled state.
Solution
To resolve the problem:
1. Use the display ip routing-table command to verify that the unicast route between the routers
is reachable.
2. Verify that a unicast route is available between the two routers that will become MSDP peers to
each other.
3. Use the display current-configuration command to verify that the local interface address and
the MSDP peer address of the remote router are the same.
4. If the problem persists, contact Hewlett Packard Enterprise Support.

No SA entries exist in the router's SA message cache

Symptom
MSDP fails to send (S, G) entries through SA messages.
Solution
To resolve the problem:
1. Use the display ip routing-table command to verify that the unicast route between the routers
is reachable.
2. Verify that a unicast route is available between the two routers that will become MSDP peers to
each other.
3. Verify the configuration of the import-source command and its ipv4-acl-number argument, and
make sure the ACL rule filters appropriate (S, G) entries.
4. If the problem persists, contact Hewlett Packard Enterprise Support.

No exchange of locally registered (S, G) entries between RPs

Symptom
RPs fail to exchange their locally registered (S, G) entries with one another in the Anycast RP
application.
Solution
To resolve the problem:
1. Use the display ip routing-table command to verify that the unicast route between the routers
is reachable.
2. Verify that a unicast route is available between the two routers that will establish an MSDP
peering relationship.
226.1.1.2 1.1.1.1
226.1.1.3 1.1.1.1
? ?
? ?
175
00:32:53 00:05:07
00:32:53 00:05:07