HP MSR1002-4 Configuration Manual page 61

Figure 19 Network diagram
Router A
50.1.1.1/24
Multicast static route
Configuration procedure
1. Assign an IP address and subnet mask for each interface, as shown in
shown.)
2. Configure OSPF on the routers in the PIM-DM domain. (Details not shown.)
3. Enable IP multicast routing, and enable IGMP and PIM-DM:
# On Router B, enable IP multicast routing.
<RouterB> system-view
[RouterB] multicast routing
[RouterB-mrib] quit
# Enable IGMP on the receiver-side interface (GigabitEthernet 1/0/1).
[RouterB] interface gigabitethernet 1/0/1
[RouterB-GigabitEthernet1/0/1] igmp enable
[RouterB-GigabitEthernet1/0/1] quit
# Enable PIM-DM on the other interfaces.
[RouterB] interface gigabitethernet 1/0/2
[RouterB-GigabitEthernet1/0/2] pim dm
[RouterB-GigabitEthernet1/0/2] quit
[RouterB] interface gigabitethernet 1/0/3
[RouterB-GigabitEthernet1/0/3] pim dm
[RouterB-GigabitEthernet1/0/3] quit
# On Router A, enable IP multicast routing.
<RouterA> system-view
[RouterA] multicast routing
[RouterA-mrib] quit
# Enable PIM-DM on each interface.
[RouterA] interface gigabitethernet 1/0/1
[RouterA-GigabitEthernet1/0/1] pim dm
GE1/0/2
40.1.1.1/24
GE1/0/2
40.1.1.2/24
GE1/0/3
30.1.1.2/24
GE1/0/1
Source
50.1.1.100/24
Router C
GE1/0/1
20.1.1.2/24
PIM-DM
GE1/0/2
20.1.1.1/24
GE1/0/3
30.1.1.1/24
Receiver
10.1.1.100/24
52
Router B
GE1/0/1
10.1.1.1/24
Figure 19. (Details not