Section 3 Unique Programming Considerations; Section 4 How To Enter Programming Mode - NEC SL2100 Installation Manual

SL2100
tells you to enter the programming mode, dial 150701 from the telephone dial pad. After you do, you
will see the message "15-07-01 TEL" on the first line of the telephone display. This indicates the
program number (15-07), item number (01), and that the options are being set for the extension. The
second row of the display "KY01 =
01. The third row allows you to move the cursor to the left or right, depending on which arrow is
*
pressed. To learn how to enter the programming mode, refer to
page 4-2.
S 3 UNIQUE PROGRAMMING CONSIDERATIONS
ECTION
When entering data, you must consider three characteristics of a program: if the program Sorts Data,
Updates the CEU or Can be Copied. The check boxes below each program heading indicate when
these options apply. If the option applies, there is a check in the appropriate box. If the option doesn't
apply, the box is empty. Following is a more detailed explanation of each option.
• Sorts Data – After you enter data for a program, the system spends several seconds sorting the
system database. Program 10-12 (Call Pickup Group) is an example of a program that sorts data.
You can continue programming normally after the sort completes. Sorting may momentarily affect
the system performance.
• Updates CEU – The system updates blades in the CEU after you change the program data. The
update may occur a minute or so after you change the data, depending on system traffic. Updating
may briefly affect the normal operation of the system.
• Can be Copied – You can use Program 92-01 to copy the program data. For example, you can
copy many of the trunk and extension programs. This saves a lot of time during initial system
programing.
S 4 HOW TO ENTER PROGRAMMING MODE
ECTION
To enter programming mode :
1. Go to any working display telephone.
In a newly installed system, use extension (port 1).
2. Do not lift the handset.
3. Press Speaker.
4. # # .
* *
4-2
15-07-01 TEL
KY01 = *01
-
IP Multiline Terminal
01" indicates that Key 01 is being programmed with the entry of
*
+
How to Enter Programming Mode on
ISSUE 1.0
PROGRAMMING