Siemens CPU 313C Hardware And Installation Manual page 107

 8VHU'HILQHG $GGUHVVLQJ RI 0RGXOHV
8VHUGHILQHG DGGUHVVLQJ
User-defined addressing means that you can assign an address of your choice to
any module (SM/FM/CP). The addresses are assigned in 67(3 . Here, you
specify the module start address that forms the basis for all other addresses of the
module.
$GYDQWDJHV RI XVHUGHILQHG DGGUHVVLQJ
• Optimization of the address areas available, since "address gaps" will not occur
between the modules.
• When creating standard software, you can program addresses which are
independent of the relevant S7-300 configuration.
 $GGUHVVLQJ 6LJQDO 0RGXOHV
,QWURGXFWLRQ
This section shows you how to address signal modules. You need this information
in order to be able to address the channels of the signal modules in your user
program.
$GGUHVVHV RI GLJLWDO PRGXOHV
The address of an input or output of a digital module consists of a byte address
and a bit address.
Example: , 
This example consists of: input ,, byte address , and bit address 
S7-300 Automation System, Hardware and Installation: CPU 31xC and CPU 31x
A5E00105492-03
$GGUHVVLQJ
8-3