Module Replacement - Siemens CPU 313C Hardware And Installation Manual

0DLQWHQDQFH
3XWWLQJ D 1HZ 0RGXOH LQWR 6HUYLFH
Proceed as follows to put the new module into service:
1. Open the front panel.
2. Reinstall the front connector.
3. Close the front panel.
4. Switch the load voltage back on.
5. Set the CPU to RUN mode again.
Figure 10-4 Inserting the front connector
 Move the front connector into operating position
 Close front panel.
%HKDYLRU RI 6 DIWHU PRGXOH UHSODFHPHQW
After module replacement the CPU switches to run mode, provided no error has
occurred. If the CPU maintains STOP status, you can view the cause of error with
67(3  (refer to the 67(3  User Manual).
10-8
P S
C P U
1
7KH ILJXUH LOOXVWUDWHV WKH GHVFULEHG VWHSV
S7-300 Automation System, Hardware and Installation: CPU 31xC and CPU 31x
2
A5E00105492-03