Assignment Of Front Connectors To Modules - Siemens CPU 313C Hardware And Installation Manual

:LULQJ
1RWH
The PS 307 power supply module is equipped with two additional DC 24 V
connections (L+ and M) for the supply of I/O modules.
 :LULQJ )URQW &RQQHFWRUV
,QWURGXFWLRQ
The front connector is used to connect the sensors and actuators of your system to
the S7-300 PLC. Wire the sensors and actuators to this front connector and then
plug it into the module.
)URQW FRQQHFWRU YHUVLRQV
Front connectors come in 20-pin and 40-pin versions, each with screw contacts or
spring terminals. 40-pin front connectors are required for CPUs 31xC and
32-channel signal modules.
You must use the following front connectors, depending on the module:
Table 7-4
Signal modules
(not 32-channel),
Function modules,
Communication module
CP 342-2
Signal modules
(32-channel) and
CPU 31xC
7HUPLQDWLRQ ZLWK VSULQJ WHUPLQDOV
To terminate a conductor in a front connector with spring terminals, simply insert
the screwdriver vertically into the opening with the red opening mechanism, insert
the wire into the terminal and remove the screwdriver.
7-8

Assignment of front connectors to modules

0RGXOH )URQW FRQQHFWRUV ZLWK
VFUHZ WHUPLQDOV 2UGHU
6ES7 392-1AJ00-0AA0
6ES7 392-1AM00-0AA0
S7-300 Automation System, Hardware and Installation: CPU 31xC and CPU 31x
)URQW FRQQHFWRUV ZLWK
VSULQJ WHUPLQDOV 2UGHU
1R
6ES7 392-1BJ00-0AA0
6ES7 392-1BM01-0AA0
1R
A5E00105492-03