Displaying And Maintaining Software Image Settings; Software Upgrade Example (For Standalone Mode); Network Requirements - HP 10500 Series Configuration Manual

1. Copies the current software images of the active MPU.
2. Specifies them as startup software images.
3. Reboots with these images.
IMPORTANT:
To ensure a successful synchronization in a multi-user environment, prevent users from rebooting or
swapping MPUs during the software synchronization process. You can configure the information center to
output the synchronization status to configuration terminals (see
Configuration Guide
To enable software synchronization from the active MPU to the standby MPU at startup:
Step
1. Enter system view.
2. Enable startup software
version check for the
standby MPU.
3. Enable software
auto-update for the standby
MPU.
Displaying and maintaining software image
settings
Execute display commands in any view.
Task
Display current software images and startup
software images (in standalone mode).
Display current software images and startup
software images (in IRF mode).

Software upgrade example (for standalone mode)

Network requirements

The device has two MPUs: one active MPU in slot 0 and one standby MPU in slot 1.
Use the file 10500.ipe to upgrade software images for the device.
).
Command
system-view
undo version check ignore
version auto-update enable
Network Management and Monitoring
Remarks
N/A
By default, startup software version
check is enabled.
By default, software version
auto-update is enabled.
Command
display boot-loader [ slot slot-number ]
display boot-loader [ chassis chassis-number [ slot
slot-number ] ]
113