Aborting A Software Activate/Deactivate Operation; Verifying Software Images; Removing Inactive Software Images; Displaying And Maintaining Issu - HP 10500 Series Configuration Manual

Aborting a software activate/deactivate operation

When the system is activating or deactivating a software image for an incremental upgrade, you can
press Ctrl+C or use the install abort command in user view to abort the operation.
After you abort a software activate or deactivate operation, the system runs with the software images that
it used before the activate or deactivate operation.

Verifying software images

When you verify software images, the following image properties are checked:
• Integrity—Whether the boot images, system images, and feature images on the device are
integral.
Consistency—Whether all cards have the same active images.
•
Confirmation status—Whether the active images on a card are confirmed.
•
If an image is not integral, consistent, or confirmed, use the install activate, install deactivate, and install
commit commands as appropriate to solve the problem.
To check the integrity and consistency of software images, execute the following command in user view:
Task
Verify the software change confirmation status and
software image integrity and consistency.

Removing inactive software images

You can remove inactive software images from the device.
IMPORTANT:
Removing a software image deletes the image file from the device permanently. You cannot use the install
rollback to command to revert the operation, or use the install abort command to abort the operation.
To remove inactive software images, execute one of the following commands as appropriate in user
view:
Task
Remove inactive software images in standalone
mode.
Remove inactive software images in IRF mode.

Displaying and maintaining ISSU

See "Displaying and maintaining
Command
install verify
Command
install remove [ slot slot-number ] { package | inactive }
install remove [ chassis chassis-number slot slot-number ]
{ package | inactive }
ISSU."
148