Displaying And Maintaining Mdcs; Mdc Configuration Example - HP 10500 Series Configuration Manual

assign an IP address to the interface. Then, administrators of the MDC can log in to the MDC by using
Telnet or SSH.
To return from an MDC to the default MDC, use the switchback or quit command.
To log in to a non-default MDC from the system view of the default MDC:
Step
1. Enter system view.
2. Log in to an MDC.

Displaying and maintaining MDCs

Execute display commands in any view on the default MDC:
Task
Display MDCs and their status.
Display the interfaces of MDCs.
Display the CPU, disk space, and memory space
usage of MDCs. (In standalone mode.)
Display the CPU, disk space, and memory space
usage of MDCs. (In IRF mode.)
Execute display commands in any view on a non-default MDC:
Task
Display the ID, name, and status of the MDC.
Display the interfaces of the MDC.
Display the CPU, disk space, and memory space
usage of the MDC. (In standalone mode.)
Display the CPU, disk space, and memory space
usage of the MDC. (In IRF mode.)

MDC configuration example

MDC configuration example
Network requirements
Configure three MDCs on the switch shown in
departments. Assign disk space, memory space, and CPU resources to the departments as required.
Command
system-view
switchto mdc mdc-name
Command
display mdc [ name mdc-name ]
display mdc [ name mdc-name ] interface
display mdc [ name mdc-name ] resource [ cpu | disk |
memory ] [ slot slot-number ]
display mdc [ name mdc-name ] resource [ cpu | disk |
memory ] [ chassis chassis-number slot slot-number ]
Command
display mdc
display mdc interface
display mdc resource [ cpu | disk | memory ] [ slot
slot-number ]
display mdc resource [ cpu | disk | memory ] [ chassis
chassis-number slot slot-number ]
Figure 50
190
Remarks
N/A
You use this command to log in to only an MDC that
is in active state.
to meet the Internet access requirements of three