RRU3268
Installation Guide
Figure 8-36 Disassembling the mounting brackets
(1) Main bracket
(5) Flat washer
1.
2.
Step 2 Place the pole installation bracket against the installation position, use a level to verify that
the pole installation bracket is placed horizontally, and then mark anchor points with a marker,
as shown in
Issue 10 (2015-12-30)
(2) Square-neck bolt
(6) Spring washer
Use an M6 inner hexagon torque screwdriver to remove the four inner hexagon screws
on the pole installation bracket, and remove the main bracket from the pole installation
bracket.
Use an M10 torque wrench to loosen the nuts on the two square-neck bolts, and remove
the plastic cap, nuts, spring washers, flat washers, square-neck bolts, and pole
installation bracket from the auxiliary bracket.
Figure
8-37.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
(3) Pole installation bracket
(7) Nut
8 Installing the RRU
(4) Auxiliary bracket
(8) Plastic cap
72