Incognito Controls; Component Test; Test Sequence And Background Information; Figure 080-4: Incognito Main Menu - Miele G 4205 Technical Information

G 5xxx
2.1.2

Incognito Controls

1. Make sure that the spray arms are not blocked.
2. Turn on the dishwasher by touching the i control.
3. The main menu is shown in the display. See Figure 080-4.
4. Select the desired program.

Figure 080-4: Incognito Main Menu

5. Select the desired program according to the type of load and soiling.
6. The display changes to the program menu.
7. Options can be added to the selected program. See Figure 080-5.

Figure 080-5: Selected Program Display

Note:
Information about the selected program can be displayed by touching the i
control.
8. Select the desired options; a √ will appear next to the option selected.
9. When finished customizing the program, confirm with OK.
10. Select Start.
11. Close the door.
2.2

Component Test

After selecting the service mode (Section 080-4.2) and successfully
accessing the component test program, individual electrical components can
be activated via the program selection button or the Start/Stop button,
depending on model. During this procedure, certain components can only be
activated via special mini-programs.
2.2.1

Test Sequence and Background Information

Note: In models without displays, one of the LEDs will flash corresponding
to the test step (e.g., one quick flash for test step 1, one slow flash and one
quick flash for step 11, etc.). In models with displays, the test step is
indicated by "Vxx", where x is the step number (e.g., "V01" for step 1).
1. R1, Y63, M6, ... Wash sequence with heating (mini-program):
This starts with 30 seconds drainage which begins with pulsed priming
(2 seconds on/2 seconds off). The water inlet valve is then activated until
1.4 gallons (5.4 liters) has been taken in. Concurrently with water inlet
valve activation, the slide shutter (if applicable) is set to the middle spray
115
Technical Information