Fault With Automatic Door Lock Latch; Service; Removing The Combination Dispenser - Miele G 4205 Technical Information

Technical Information
3.2

Fault with Automatic Door Lock Latch

Symptom:
The closing function of the automatic door lock latch is time-controlled. As
soon as the given time has elapsed, the fault indication Fault with auto.
door closing is displayed. This fault indication can also be displayed if the
door is forcefully slammed shut.
If there is a fault with the opening function, the fault indication Fault
with auto. door opening is displayed.
Cause:
Incorrect operation and/or door closing obstructed.
The time fault can occur, e.g., if a dishtowel between the door and the cabinet
is obstructing the closing action. As soon as the allotted time for door closing
has elapsed, a fault is registered and indicated in the display.
If the door is slammed shut too forcefully, the motorized latch can be forced
out of position, causing a fault to be registered.
Remedy:
The fault is reset by switching the appliance off and on, and then closing the
door correctly.
4

Service

4.1

Removing the Combination Dispenser

1. Uninstall the appliance.
2. Disconnect the appliance from the power supply.
3. Remove the door outer panel. See Section 030-4.3.
4. Disconnect all dispenser plug connections.
5. Remove the six T20 screws securing the combination dispenser to the
door inner panel (Figure 020-13, Item 1).
6. Release the retaining clips (2 on top, 1 on bottom) and press the
dispenser assembly out of the door inner panel.
7. After replacing the combination dispenser, check it for correct operation
using the service mode.
50
G 5xxx