Cisco TelePresence DX70 Reference Manual page 6

Cisco TelePresence DX70 and DX80

Introduction Introduction
Certificate upload via API
ASCII PEM formatted certificates can be installed directly
xCommand Security
using multiline API commands (
Ceritifcates CA Add xCommand Security Ceritifcates
, or
Services Add
). You can also upload certificates to a video
system from its web interface, as before.
API commands for user management
You can create and manage user accounts directly using API
xCommand UserManagement User *
commands (
you can also do this from the video system's user interface.
Preview mode for In-Room Controls
The In-Room Control editor has a new preview mode. A
virtual touch interface shows how the design looks on the
user interface. The user interface is interactive so that you
can test the functionality. It produces real events on the video
system, which can trigger any functionality you have created
with a third-party control system or with a macro. A console
in the right pane displays both the widget values when inter-
acted with, and control system feedback messages.
Intelligent Proximity changes
A Proximity indicator is displayed on the screen (middle right)
to inform that one or more clients are paired to the system
with Cisco Proximity. The old indicator (top left), which
was always shown when Proximity was enabled, has been
removed.
You can no longer disable the Proximity services from the
user interface.
The ultrasound settings have moved from Peripherals Pairing
Ultrasound to Audio Ultrasound.
D15363.05 Cisco TelePresence DX70 and DX80 API Reference Guide CE9.2, NOVEMBER 2017.
About the API xConfiguration
Automatic factory reset when changing the call service
(device activation)
The video system will automatically factory reset and restart
when using the user interface to change the device activa-
tion method, for example from VCS to Cisco UCM. This will
prevent conflicting configurations when provisioning the video
system to a new service.
Changing the provisioning from the API will not automatically
factory reset the video system.
). As before,
Support for separate RTP port ranges for audio and other
media
You can configure the video system so that audio uses a
different RTP port range than other media. The two ranges
cannot overlap. As default, all media use the same RTP port
range.
xCommand
6
API Reference Guide
xStatus Appendices
Copyright © 2017 Cisco Systems, Inc. All rights reserved.