Safety Precautions - Panasonic EA-7HW02AP1 User Manual

Wireless lan access point
Table of Contents

Advertisement

Safety Precautions

To prevent severe injury and loss of life/property, read this section carefully before using the unit to ensure proper
and safe operation of your unit.
WARNING:
Changes or modifications not expressly approved by the party responsible for compliance could void the user's
authority to operate this equipment.
To prevent injury, this apparatus must be securely attached to the wall/ceiling in accordance with the installation
instructions.
All work related to the installation of this product should be made by qualified service personnel or system
installers.
The installation shall be carried out in accordance with all applicable installation rules.
The connections should comply with local electrical code.
CAUTION:
Compliance with FCC requirement 15.407(c)
Data transmission in always initiated by software, which is the passed down through the MAC, through the digital
and analog baseband, and finally to the RF chip. Several special packets are initiated by the MAC. These are the
only ways the digital baseband portion will turn on the RF transmitter, which it then turns off at the end of the packet.
Therefore, the transmitter will be on only while one of the aforementioned packets is being transmitted. In other
words, this device automatically discontinue transmission in case of either absence of information to transmit or
operational failure.
AC adaptor with ferrite core must be used for RF interference suppression.
Frequency Tolerance: ±20 ppm
This device is restricted for indoor use.
This device and it's antennas(s) must not be co-located or operating in conjunction with any other antenna or
transmitter except in accordance with FCC multi-transmitter product procedures.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This
equipment should be installed and operated with minimum distance 36 cm between the radiator & your body.
equipment should be installed and operated with minimum distance 20 cm between the radiator & your body.
3

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ea-7hw03ap1

Table of Contents