Panasonic EA-7HW02AP1 User Manual page 52

1. Power feeding from PoE unit
Power will be fed from PoE power feeding equipment compliant with IEEE802.3af or IEEE802.3at.
In this section, descriptions of how to feed power from PoE injector are provided.
By following the procedures below, connect the PoE injector and other cables.
(1) Insert the plug of the Ethernet cable connected with the ETH1 (PoE) connector of the wireless unit to the "DATA
& POWER OUT" port of the PoE injector until the "click" sound is heard.
(2) Connect the provided power cable to the PoE injector.
(3) Insert the power plug of the PoE injector to an outlet of 100 V AC. (The POWER LED will light yellow and then
turn to green.)
(4) Insert the plug of the Ethernet cable connected with a host network device to the "DATA IN" port of the PoE
injector until the "click" sound is heard.
ETH1( PoE) connector
Important
•
The wiring length from the wireless unit to the host network device shall be up to 100 m (total).
•
Do not pull the connected cables with a strong force.
•
Do not place a heavy object on the PoE injector.
•
Do not perform wiring of the connection cables and the Ethernet cable connection section in a place where
water can damage them.
52