Connecting To The Edge Gateway - Dell Edge Gateway 3002 Installation And Operation Manual

Connecting to the Edge Gateway

Windows 10 IoT Enterprise LTSB 2016
Boot up and login – Remote system configuration
NOTE: Your computer must be on the same subnet as the Edge Gateway.
1. Connect a network cable from Ethernet port one on the Edge Gateway to a DHCP-enabled network or router that provides IP
addresses.
NOTE: The first-time boot to Windows takes about 5 minutes for system configuration. Subsequent boot-ups take
about 50 seconds.
2. Using the MAC address provided on the front cover of the Edge Gateway, obtain the IP address through your network's DHCP
server or through a network analyzer.
3. On the Windows computer, search for Remote Desktop Connection and launch the application.
4. Log in using the IP address.
NOTE: Ignore any certification errors when connecting to your Edge Gateway.
Boot up and login—Static IP system configuration
NOTE: To help set up the Edge Gateway remotely, the static IP address of Ethernet port two on the Edge Gateway is set
to these values at the factory:
• IP address: 192.168.2.1
• Subnet mask: 255.255.255.0
• DHCP server: Not applicable
You can connect your Edge Gateway to a Windows computer that is on the same subnet using a crossover cable.
1. On the Windows computer, search for View network connections in the control panel.
2. In the list of network devices displayed, right-click the Ethernet adaptor that you want to use to connect to the Edge Gateway,
then click Properties.
3. On the Networking tab, click Internet Protocol Version 4 (TCP/IPv4) → Properties.
4. Select Use the following IP address, then enter 192.168.2.x (where x represents the last digit of the IP address, for
example, 192.168.2.2).
NOTE: Do not set the IPv4 address to the same IP address as the Edge Gateway. Use an IP address between
192.168.2.2 to 192.168.2.254.
5. Enter the subnet mask 255.255.255.0 , then click OK.
6. Secure a crossover network cable between Ethernet port two on the Edge Gateway and the configured Ethernet port on the
computer.
7. On the Windows computer, launch Remote Desktop Connection.
8. Connect to the Edge Gateway using the IP address 192.168.2.1. The default username and password are both admin.
Ubuntu Core 16
Boot up and log in – Direct system configuration
1. Power on the Edge Gateway. The system sets up the operating system automatically and restarts multiple times to apply all the
configurations. The system takes approximately one minute to boot to the operating system.
2. When prompted, log in using the default credentials. The default user name and password are both admin. The default
computer name is the service tag.
75