NOTE: The IG signal can be used to gracefully shutdown or enter low-power state when the vehicle is turned off (battery
powered). It can also be used for powering on the Edge Gateway when the vehicle starts.
Right view
Table 6. Right view—3002
Features
1
CANbus port
1
2
USB 2.0 port
3
Ethernet port two (Non-PoE)
1
USB power is limited to 0.4 A/2 W.
Table 7. CANbus-port pin definition details
Features
1
2
3
10
Enables the CANbus connection.
Connect a USB enabled device. Provides data transfer speeds up
to 480 Mbps.
Connect an Ethernet (RJ45) cable for network access. Provides
data transfer speeds up to 10/100 Mbps.
GND
CAN-H
CAN-L
Ground
High-level CANbus line
Low-level CANbus line