Table of Contents
Advertisement
4
Station Automation COM600 3.4
IEC 60870-5-101 Slave (OPC) User's Manual
3.4.5.6.
3.4.5.7.
3.4.5.8.
3.4.5.9.
3.4.5.10.
3.4.5.11.
3.4.5.12.
3.4.5.13.
3.4.5.14.
3.4.5.15.
3.4.5.16.
3.4.5.17.
4.
Operation ............................................................................................... 52
4.1.
About this section ......................................................................... 52
4.2.
Activating COM600 with new configurations ............................... 52
4.3.
IEC101 Slave OPC Client diagnostics ......................................... 52
4.4.
IEC101 Channel diagnostics ....................................................... 53
4.5.
IEC101 Device diagnostics .......................................................... 54
4.6.
Signal diagnostics ........................................................................ 54
5.
Technical reference .............................................................................. 56
5.1.
About this section ......................................................................... 56
5.2.
IEC 61850 data modeling ............................................................ 56
5.2.1.
General about IEC 61850 data modeling ...................... 56
5.2.2.
Single point status (SPS) .............................................. 56
5.2.3.
Double point status (DPS) ............................................ 57
5.2.4.
Integer status (INS) ....................................................... 57
5.2.5.
Protection activation information (ACT) ........................ 57
5.2.6.
Directional protection activation information (ACD) ...... 58
5.2.7.
Binary counter reading (BCR) ....................................... 59
5.2.8.
Measured value (MV) .................................................... 59
5.2.9.
Complex measured value (CMV) .................................. 59
5.2.10.
WYE .............................................................................. 60
5.2.11.
Delta (DEL) ................................................................... 60
5.2.12.
Controllable single point (SPC) ..................................... 61
5.2.13.
Controllable double point (DPC) ................................... 61
5.2.14.
Controllable integer status (INC) ................................... 62
5.2.15.
Binary controlled step position information (BSC) ........ 62
5.2.16.
Integer controlled step position information (ISC) ......... 62
5.2.17.
Analogue set point (APC) ............................................. 63
5.3.
Status codes ................................................................................ 63
5.3.1.
Introduction ................................................................... 63
5.3.2.
Link layer status codes ................................................. 63
Directional protection activation information
(ACD) .......................................................... 37
Binary counter reading (BCR) .................... 38
Measured value (MV) ................................. 39
Complex measured value (CMV) ............... 41
WYE ........................................................... 42
Delta (DEL) ................................................. 43
Controllable single point (SPC) .................. 45
Controllable double point (DPC) ................. 46
Controllable integer status (INC) ................ 48
Binary controlled step position information
(BSC) .......................................................... 49
Integer controlled step position information
(ISC) ........................................................... 50
Analogue set point (APC) ........................... 51
1MRS755382
Advertisement
Table of Contents
