NEC Express 5800 Series User Manual page 49

BMC Configuration User's Guide
Item
Basic Configuration
POST Error Pause
Memory Error *2
CLI Setup *2
Standby Power Save *2
Serial Port A Configuration
Serial Port A
Serial A Base I/O
Serial A Interrupt
Serial Port B Configuration
Serial Port B
Serial B Base I/O
Serial B Interrupt
Console Redirection Configuration
BIOS Redirection Port
Terminal Type
Baud Rate
Data Bits
Stop Bits
Parity
Flow Control
Continue C.R. after POST
*1: The value might be different according to the system.
*2: It is not displayed when the system does not support this function.
CHECK:

This setting item does not exist in Off-line TOOL.
Description
Basic Configuration setting
Select Enable/Disable of POST Error Pause.
Select Halt/Boot of Memory Error.
Select Enable/Disable of CLI Setup.
Select Enable/Disable of Standby Power Save.
Serial Port A Configuration setting
Select Enable/Disable of Serial Port A.
Select Base I/O Address of Serial Port A. It
must be different from Serial Port B.
Select IRQ of Serial Port A. It must be different
from Serial Port B.
Serial Port B Configuration setting
Select Enable/Disable of Serial Port B.
Select Base I/O Address of Serial Port B. It
must be different from Serial Port A.
Select IRQ of Serial Port B. It must be different
from Serial Port A.
Console Redirection Configuration setting
Select BIOS Redirection Port. You can not
select "Disable" Port.
Select Terminal Type.
Select Baud Rate.
Select Data Bits.
Select Stop Bits
Select Parity.
Select Flow Control.
Select Enable/Disable of Continue Console
Redirection after POST.
Default Value *1
Enable
Boot
Disable
Disable
Enable
3F8h
IRQ 4
Enable
2F8h
IRQ 3
Disabled
VT-100+
115200
8
1
None
Hardware
RTS/CTS
Enable