NEC Express 5800 Series User Manual page 74

BMC Configuration User's Guide
Item
SNMP Alert
Alert*1
Computer Name
Community Name
Alert Process
Alert Acknowledge
Alert Retry Count
Alert Timeout
Alert Receiver
Primary IP Address
IP Address
Secondary IP Address
IP Address
Tertiary IP Address
IP Address
Alert Level
Alert Level
Alert Test
*1: When PEF(Platform Event Filter) setting is "Disable", it can not alert.
*2: It is possible to set less than 16 half-size alphanumeric characters.
*3: It is possible to set when Alert Acknowledge is "Enable".
*4: When SNMP Alert is enabled, one or more of the addresses should be enable.
*5: It is possible to set when each Alert Receiver is"Enable".
*6: The Alert Level are as follows:
Alert Level
Error
Error/ Warning
Error/ Warning/ Information
Separate Setting
Description
SNMP Alert setting
Select Enable/Disable of SNMP Alert.
Set the Computer Name. *2
Set the Community Name. *2
Select One Alert Receiver/All Alert Receiver of Alert
Process.
Select Enable/Disable of Alert Acknowledge.
Set the count of Alert retry. *3
Set the seconds to alert timeout. *3
Alert Receiver setting.
Select Enable/Disable of Primary IP Address. *4
Set the IP Address of Primary. *5
Select Enable/Disable of Secondary IP Address. *4
Set the IP Address of Secondary. *5
Select Enable/Disable of Tertiary IP Address. *4
Set the IP Address of Tertiary. *5
Alert Level setting
Set the kind of event to alert. *6
Execute the alert test by SNMP.
Description
When "Error" is detected in each sensor type, the alert is sent to the checked
address.
When "Error" or "Warning" is detected in each sensor type, the alert is sent to
the checked address.
When "Error", "Warning" or "Information" is detected in each sensor type, the
alert is sent to the checked address.
You can arbitrarily select the event to alert in each sensor type.
Default Value
Disable
Blank
public
One Alert Receiver
Enable
3
6
Enable
0.0.0.0
Disable
0.0.0.0
Disable
0.0.0.0
Error/ Warning