Siemens sitrans LR 400 Instruction Manual page 61

6.3: Service Interval
The device monitors the time it has been in service, and when additional service may be
required. A factory default can be reset by the user.
6.3.1: Time Elapsed since Last Service
6.3.2: Maintenance Required Limit
6.3.3.: Maintenance Demanded Limit
6.3.4.: Maintenance Alert Activation
6.3.5: Total Service Interval
6.3.6: Units
6.3.7: Maintenance Status
6.3.8: Acknowledge Status
6.3.9: Acknowledge
6.4: Calibration Interval
The device monitors the time since it was last calibrated, and when additional calibration
may be required. A factory default can be reset by the user.
6.4.1: Time Elapsed Since Last Calibration
6.4.2: Maintenance Required Limit
6.4.3: Maintenance Demanded Limit
6.4.4: Maintenance Alert Activation
6.4.5: Total Calibration Interval
6.4.6: Units
6.4.7: Maintenance Status
6.4.8: Acknowledge Status
6.4.9: Acknowledge
1.
Data for these parameters must be entered in seconds
Page 58 SITRANS LR 400 (Solids) – INSTRUCTION MANUAL
1
1
1
1
1
1
7ML19985JC02