Sony LKRA-009 Installation Manual page 168

Play SPL including intermission
If you want to play an SPL with 4D content including intermission setting, you may have to stop 4D
system temporarily when switching Interval SPL, and restart 4D system when Interval SPL will end.
In this case, set automation cues (stop and restart) in the interval SPL and specify the time of Interval SPL
as an Interval Time. If you set a shorter time than the Interval SPL, network automation cue for 4D con-
trol may not be executed. Contact your local Sony Sales Office/Service Center whether these settings are
required or not. As for the intermission settings, refer to the Operating Instructions.
Black
SPL CPL CPL CPL
1 2
Show starting from the mid of 48P/50P/60P content
Show stopping temporarily in the mid of 48P/50P/60P content and resuming it after that
The LTC output may "slip" (lose frame synchronization temporarily) with the content over 30P frame rate
when the show is resumed from the middle or after pausing. This is caused because the LTC is output with
each 2 frames for content over 30P frame rate.
Note that this "slip" of LTC output synchronization may cause misdetection of the time code in the LTC
input to the 4D system. For details, contact your local Sony Sales Office/Service Center
7-10 (E)
Stop Point
CPL (4D)
Black
CPL
Interval SPL
3
Restart Point
CPL (4D)
Black
CPL
1 2
1 2 [4D Start] automation cue
[4D Stop] automation cue
3
Black
3
Digital Cinema Dual System